Hey guys! This Friday I’m signing off for the weekend with a pair of figures that us Halo MEGA fans have dreamed of - The Halo 2: Anniversary Brute Honor Guard! These armor sets (Helmet, Harness, Shoulders, Thighs) are all 3D printed and gifted to me to customize! To start us off, I repainted the entire body of figures in Stormvermin Grey, adding a Iron Legions dry brush to the fur. The straps and harnesses on the thighs, chest, and shoulders were repainted in Drayd Bark Brown before being dry brushed with the same Iron Legions. Next, Khorne red was applied to the necessary areas, along with hints of Leadbelcher and Corvus Grey. The ornamental crests were hand painted in a fade from Yriel Yellow and Trollslayer orange, then washed in a soft tone to saturate the color. The final touches were some additional Corvus Grey details across the chest and shoulders, as well as the dry brushed straps all around the ankles. While the armor is a bit bulky in certain places, the silhouette it provides is nothing short of legendary. Thank you to customakia and the folks at perronesd for sending these over - make sure to follow and leave your comments below. Enjoy!