Skeletor was needing some reinforcements so I used a spare He-Man to give him Tri-Klops. Body is all He-Man. Head is a CoD figure with the T-post on his head for headgear. I designed up a peg to fit over the T-post and then designed his headpiece and printed both out. The head piece fits down over his head, then the peg clips onto the T-post to keep it from sliding off. I put a bit of UV resin around his head, just under where the headpiece sits to keep it from sliding down or getting uneven. The headpiece will spin to allow showing all three eyes - normal, angry, and super-mad. I thought about doing the cartoon's triangle, circle, and square eyes but decided against it.
I then designed up the harness using measurements off the He-Man body and printed it out. I wish it sat a little lower on his shoulders so he had more of a neck, but it's not too bad in person. I then designed the sword and printed it out. I'll probably modify it a bit and print it out again at a higher resolution but it works for now.
Thanks for looking!
I then designed up the harness using measurements off the He-Man body and printed it out. I wish it sat a little lower on his shoulders so he had more of a neck, but it's not too bad in person. I then designed the sword and printed it out. I'll probably modify it a bit and print it out again at a higher resolution but it works for now.
Thanks for looking!